Differences

This shows you the differences between two versions of the page.

--- plugcopter [2015/04/06 02:41] – [Parts] donpdonp
+++ plugcopter [2024/01/31 04:08] (current) – external edit 127.0.0.1
@@ Line 15: / Line 15: @@
 ## Parts
   * frame
-    * 3D printed: Fuselage, Motor Arms, Motor Mounts
+    * 3D printed: Fuselage, Motor Arms, Motor Mounts $5 guess
-    * 230mm framd($22) [[http://www.hobbyking.com/hobbyking/store/__61390__Laser230_FPV_Quadcopter_Composite_Kit_230mm_.html|Hobbyking]]
+    * 230mm ($22) [[http://www.hobbyking.com/hobbyking/store/__61390__Laser230_FPV_Quadcopter_Composite_Kit_230mm_.html|Hobbyking]]
   * Flight Controller
-    * Teensy LC primary processor ($11) [[http://www.pjrc.com/teensy/teensyLC.html|PJRC]]
+    * PlugCopter Flight Computer ($20)
     * KK-Mini atmega 644PA 64k flash, 4k ram [[http://www.hobbyking.com/hobbyking/store/__56392__HobbyKing_174_KK_Mini_Multi_Rotor_Flight_Control_Board_36x36mm_30_5x30_5mm_.html?utm_campaign=140827.USE&utm_content=1488796016&utm_medium=email&utm_source=EDM|HobbyKing]] ($25 w/ 6050MPU)
     * OpenPilot CC3D ($14) [[http://www.banggood.com/OpenPilot-CC3D-Flight-Controller-STM32-32-bit-Flexiport-p-937044.html|BangGood]]
@@ Line 38: / Line 38: @@
     * Lipo2S to 5v ($5) 3amp [[http://www.hobbyking.com/hobbyking/store/__4319__TURNIGY_3A_UBEC_w_Noise_Reduction.html|HobbyKing]]
-Total: $
+Total: $5 3d frame + $20 plug FC + $14x4 motors+esc + $2 6050 + $2 ESP8266 + $5 5v reg = $90
-## motherboard
+## PlugCopter Flight Computer Motherboard
 An OSHPark pcboard using through-hole tech to be heart of the copter.
-size: 2" x 1"
+  * 2"x1" OshPark PCBoard $3
-cost: $10/3
+  * Teensy-LC $11
+  * 3.3v reg $2
+  * LEDs $2
 Power lines
@@ Line 71: / Line 73: @@
 ## Kit parts
+  * Teensy LC primary processor ($11) [[http://www.pjrc.com/teensy/teensyLC.html|PJRC]]
   * LD1117V33 Low Drop Out Regulator by ST, 3.3V, TO-220
   * LEDs x 4
-  *
 ## Names
   * ProtoH
-  * PlugCopter
+  * PlugCopter (2015 Apr)
   * SocketCopter